Table of Contents
Advertisement
5. Installation and Wiring
■Ejecting an SD Card
To eject an SD card from the SD card slot, always use the following steps.
(1) Press and hold the SD card save button for 5 seconds or longer.
(2) After the buzzer sound stopped and the SD card access indicator turned off, release
the SD card save button.
(3) Insert th e SD card in the back until you hear a click sound, then release the card.
(4) Pick an end of the SD card and draw it out from the SD card slot.
Precautions
- Before inserting/ejecting an SD card, discharge static electricity by touching a grounded metal
object, etc.
■Dummy SD Card
A dummy SD card is attached to the SD card slot upon factory shipment.
To use an SD card, remove the dummy SD card before.
If you do not use any SD card, keep the dummy SD card in the SD card slot to protect the slot.
Reference
- Upon the 1st SD card output after EQ100 setup, all data stored before then are outputted. If
the amount of data that are not saved for a long time exist, output will take a long time to
finish.
- A restarting operation through Web UI or the reset button automatically unmounts the SD card,
turns off the SD BUSY LED indicator, and restarts the product.
5-12
Advertisement
Table of Contents
