Omron EQ100-E User Manual page 83

6. Measurement Device Setup and Connection
Type Name (Model)
CT Expansion Unit
(KE1-CTD8E)
1/32 DIN Digital Panel
Meter
(K3GN--FLK)
Temperature Controller
(E5□C)
LAN-Connected Air Particle Sensor
Measurement
(ZN-PD-S)
Device
Air Thermo Station
(ZN-THX21-S)
Portable Power Monitor
(ZN-CTX21)
Power Sensor Station
(ZN-KMX21)
Differential Pressure
Station
(ZN-DPX21-S)
Air Flow Station
(D6FZ-FGX21)
Wireless Device Wireless Unit Master
Unit
(WZ-MLAN01)
Setup for EQ100
Connection
Electrical system 1/2 applicable
phase wire, measurement block 1/2
special CT, electrical system 1/2 VT
ratio, measurement block 1/2 CT
ratio, measurement start time,
measurement end time, active input
setting
Input type, analog range, pulse
frequency
Input type, scaling upper limit, scaling
lower limit, decimal point position,
temperature unit, transmission output
type, transmission output upper limit,
transmission output lower limit,
protocol
- IP address
Particle selection 1, particle selection
- Subnet mask
2, display unit, measurement mode
- Others (default
Operation mode, measurement
gateway, port
mode, collecting mode, measurement
number)
frequency
Operation mode, measurement
mode, collecting mode, measurement
cycle, electric energy reset interval,
applied circuit, special CT, used
channels, measurement target
voltage, measurement range, begin
time, end time, start trigger, end
trigger, REC recovery upon startup
Collecting mode, measurement cycle,
Power Sensor /connected monitors,
electric energy reset interval, REC
recovery upon startup
Operation mode, measurement
mode, collecting mode, measurement
frequency
Collecting mode, measurement cycle,
conversion coefficient, conversion
unit setting, display unit,
communication conversion port
number
- IP address
- Subnet mask
- Others (default
gateway, port
number)
- Group ID
- Others (wireless
channel,
broadcast
communications,
HTTP port
number)
Basic Measurement Setup for
Measurement Devices
-
6-5