Table of Contents
Advertisement
7. EQ100 Settings
Setting Item
Registered
Enter the number of measurement devices to register.
Number
Address
If you select this check box, you can register IP addresses or unit
Increment
numbers increased step-by-step by one from the one entered in the [Add
Measurement Device] screen.
If cleared, the same values are entered as the address.
3) Clicking [OK] registers KM100 together.
A number is added to
the tail sequentially.
4) If the batch-registered address and/or measurement cycle are not desirable, modify the
value.
To modify, click the [Edit] button of the device name you want to modify. For operations, see "
■Editing Measurement Device" in the later section.
■Editing Measurement Device
To change registration details of a measurement device:
1) Click the [Edit] button of the measurement device you want to change.
2) In the [Edit Measurement Device] dialog box, change the registration details.
Note that you cannot edit the default channel registration and group to add. You must edit on
the channel registration and group registration.
3) Clicking [OK] changes the registration of the measurement device.
Precautions for
Correct Use
- If a measurement cycle of a measurement device is changed to a longer value during the
system operations, total values for one cycle including the changed hour cannot be properly
collected.
Description
Selecting the [Address Increment] check box
increments addresses by one.
7-18
Advertisement
Table of Contents
