Table of Contents
Advertisement
7. EQ100 Settings
<EQ100 General-Purpose Input Terminal (Pulse Input) Measurement Device>
Setting Item
Device Name Enter a name of the measurement device. If not entered, "EQ100
PULSE"+"#" is automatically set.
<Input range> Half-width63 characters (Full-width 20 characters, more or
less)
Device Type
Select [EQ100 PULSE].
Setting Items Details depend on a selected measurement device type.
[Measurement Cycle]: Select a collecting interval for the measurement
device.
<Selection> 1min/5min/10min/30min/60min
Default
<Default Channel Registration>
Channel
One channel of [EQ100 PULSE] can be registered to channel registration
Registration
and group registration.
<Destination Group to Add>
If the [Destination group to Add] check box is selected, measurement
device channels can be registered to a specified group at the same time.
To use this function, first register a group.
For registration, see "7.4.7. Group Registration".
Note that performing the default registration without performing group
registration registers to a default "group".
3) Clicking [OK] registers the measurement device.
Description
7-16
Advertisement
Table of Contents
