Table of Contents
Advertisement
7. EQ100 Settings
<PLC>
Setting Item
Device Name
Enter a name of the PLC measurement device.
Channel Name
Enter a channel name. If not entered, "Measurement Device
Name"+"#"+"channel address" is automatically set.
<Input range> Half-width63 characters (Full-width 20 characters, more or
less)
Data Type
Select a data type.
Type
Select a data type.
Variable Area
Select an area type of I/O memory.
Start Address
Enter the start address.
Start Bit
Select the start bit.
Differential
Select Yes or No for differential processing.
Processing
No: A channel is handled as an instantaneous value.
Yes: A channel is handled as an integrated value.
Preprocess
Click [Edit] and enter a coefficient and a constant value.
Range of Values Specify a maximum value for a target to read if the differential processing
is required. Configuring this allows proper differential processing even if a
value is reset to 0 after reaching the maximum value. The minimum value
is fixed to 0.
Destination
If the [Destination Group to Add] check box is selected, channels can be
Group to Add
registered to a specified group at the same time.
To use this function, first register a group.
For registration, see "7.4.7. Group Registration".
Note that performing the registration without performing group
registration registers to a default "group".
Description
7-21
Advertisement
Table of Contents
