KYMCO MX’er 125 Service Manual page 70

5
. FUEL SYSTEM
Install the carburetor onto the intake manifold
and tighten the two lock nuts.
Torque: 0.8 1.2kgf-m
Install the air cleaner connecting tube and tighten
the band screw.
THROTTLE VALVE ASSEMBLY
Install the jet needle into the throttle valve and
secure with the needle retainer.
Jet Needle Notch: 4th Notch
(Counted from top to bottom)
Assemble the rubber cover, carburetor cap and
throttle valve spring.
Connect the throttle cable to the throttle valve.
Install the throttle valve into the carburetor
body.
*
Align the groove in the throttle valve with
the throttle stop screw on the carburetor
body.
Connect the accelerating pump cable.
Fully open the throttle and adjust the
accelerating pump cable to align the punch mark
on the accelerating pump arm with the punch
mark on the set plate.
Lock Nut
Band Screw
Clip
Jet Needle
Throttle Valve
Carburetor Cap
Throttle Valve
Throttle Stop Screw
Tighten the choke cable.
MX'er SYSTEM
Needle Retainer
Spring
Notch
Groove
5-8