KYMCO MX’er 125 Service Manual page 110

9. DRIVE AND DRIVEN PULLEYS
DRIVEN PULLEY FACE BEARING
REPLACEMENT
Drive the inner needle bearing out of the driven
pulley face.
*
Discard the removed bearing and replace
with a new one.
Remove the snap ring and drive the outer bearing
out of the driven face.
*
Discard the removed bearing and replace
with a new one.
Apply grease to the outer bearing.
Drive a new outer bearing into the driven face
with the sealed end facing up.
Special
Bearing Puller E008
Seat the snap ring in its groove.
Apply grease to the driven face bore areas.
*
Pack all bearing cavities with 9 9.5g
grease.
Specified grease: Heat resistance 230°C
Press a new needle bearing into the driven
face.
Special
Oil Seal And Bearing Install E014
CLUTCH DISASSEMBLY
Remove the circlips and retainer plate to
disassemble the clutch.
*
Keep grease off the clutch linings.
MX'er SYSTEM
Inner Bearing
Outer Bearing
Retainer Plate
9-10