KYMCO MX’er 125 Service Manual page 158

13
. REAR WHEEL/SWING ARM/
HYDRAULIC BRAKE
Use the nut wrench to loosen two nuts (inner
and outer) of the rear axle.
Special
Nut wrench F010
Remove the cotter pin.
Remove four nuts attaching the wheel panel of
the both rear wheels.
Loosen nut attaching the wheel hub of the both
rear wheels.
*
Elevate the rear wheels by placing a
suitable stand under the rear of frame.
Support the machine securely so there is no
danger of it falling over.
Remove
Remove four nuts attaching the wheel panel and
rear wheel.
Remove nut attaching the wheel hub and
washer.
Remove the wheel hub.
Outer Nut
Cotter Pin
Nut Attaching The Wheel Hub
Wheel Hub
Wheel Panel Nuts
Inspection
Inner Nut
Measure the wheel runout.
Service Limit:
MX'er SYSTEM
Nuts Attaching The Wheel Panel
Vertical: 2.0 mm
Washer
Wheel Hub Nut
13-4