13
. REAR WHEEL/SWING ARM/
HYDRAULIC BRAKE
Remove the oil seal by a flat-head screw
driver.
*
Place a wood block against the outer
edge to protect this edge.
Remove the bearing by a general bearing puller.
Install the new bearings and oils seal by
reversing the previous steps.
*
Do not strike the center race or balls of
the bearing.
Contact should be made only with the
outer race.
INSTALLATION
Reverse the "REMOVAL" procedures.
*
Apply grease onto the oil seal lips,
bearings and bushes.
Install the rear axle hub.
*
At this time, the rear axle hub should not
be tightened completely.
Final tightening is done after the chain
slack adjustment.
Install the rear axle.
*
Tap the axle and with a rubber hammer,
this will avoid damage the axle thread.
Bearings
Oil Seal
Install the brake drum.
Install the rubber spacer and brake drum
cover.
Torque: 0.8 1.2kgf-m
MX'er SYSTEM
13-10