KYMCO MX’er 125 Service Manual page 113

9. DRIVE AND DRIVEN PULLEYS
Driven Face
Compress the clutch spring compressor and
install the drive plate nut.
Set the clutch spring compressor in a vise and
tighten the drive plate nut to the specified
torque.
Torque: 5.0 6.0kgf-m
*
Be sure to use a clutch spring compressor
to avoid spring damage.
Special
Clutch Spring Compressor
INSTALLATION
Install the clutch/driven pulley onto the drive
shaft.
*
Keep grease off the drive shaft.
Install the clutch outer.
Hold the clutch outer with the flywheel
holder.
Install and tighten the clutch outer nut.
Torque: 5.5kg-m
Special
Universal Holder
Install the drive belt.
Install the drive pulley face, starting ratchet
and drive face nut.
*
When installing the drive pulley face, compress
it to let the drive belt move downward to the
lowest position so that the drive pulley can be
tightened.
Install the starting ratchet by aligning the starting
ratchet teeth with the crankshaft teeth.
Do not get oil or grease on the drive belt or
pulley faces.
9-13
E027
E017
T orque: 5.5 6.5kgf-m
Clutch Spring Compressor
Lock Nut Wrench
Driven Pulley
Clutch Outer
Universal Holder
Universal Holder
Nut
MX'er SYSTEM
Clutch
Drive Pulley