KYMCO MX’er 125 Service Manual page 141

12
. FRONT WHEEL/FRONT BRAKE/FRONT
SUSPENSION/STEERING SYSTEM
REMOVAL
Inspect the shoe springs, O-rings, camshaft
lever and wear indicator.
Replace if damage.
Inspect the brake shoe plate.
Replace if cracks or damage.
Inspect the brake shoe pivot pin.
Replace if wear or damage.
Inspect the camshaft hole and camshaft.
Replace if scratches or excessive wear.
INSTALLATION
Reverse the "REMOVAL" procedures.
*
• Install the camshaft to the brake shoe plate
with the slot of the camshaft placing at
bass line of the wear indicator scale.
• Align the projection with the slot of the
camshaft when installing the wear indicator
to the camshaft.
• Align the cut-out of the camshaft lever
with the slot of the camshaft when
installing the camshaft lever to the
camshaft.
Tighten the bolt for camshaft lever.
Torque: 1.8 2.5kgf-m
*
Apply the grease onto the o-ring, oil seal
lips, pivot pin of brake shoe and camshaft.
Brake Lining
12-7
Camshaft lever
Brake Plate
Wear Indicator
Camshaft Hole
O-rings
Camshaft
Install the brake shoe plate.
*
Make sure that the boss on the knuckle
correctly engages with the locating slot on
the brake shoe plate.
MX'er SYSTEM
Brake shoe pivot pin
Oil Seal
Springs