KYMCO MX’er 125 Service Manual page 108

9. DRIVE AND DRIVEN PULLEYS
Driven Pulley
Hold the clutch/driven pulley assembly with the
clutch spring compressor.
*
Be sure to use a clutch spring compressor
to avoid spring damage.
Special
Clutch Spring Compressor
Set the clutch spring compressor in a vise and
remove the clutch drive plate nut.
Loosen the clutch spring compressor and
disassemble the clutch/driven pulley assembly.
Remove the seal collar.
Check the driven face for wear or damage.
Measure the clutch lining thickness.
Service Limit: 2.0mm replace if below
Pull out the guide roller pins and guide rollers.
Remove the movable driven face from the driven
face.
E027
MX'er SYSTEM
Clutch Spring Compressor
Lock Nut Wrench
Guide Roller Pin
O-ring
9-8