KYMCO MX’er 125 Service Manual page 174

13
. REAR WHEEL/SWING ARM/
HYDRAULIC BRAKE
from the brake master cylinder.
Clean the inside of the master cylinder and
brake reservoir with brake fluid.
INSPECTION
Measure the brake master cylinder I.D.
Inspect the master cylinder for scratches or
cracks.
Service Limit: 12.75mm replace if over
Measure the brake master cylinder piston O.D.
Service Limit: 12.64mm replace if below
Snap Ring Pliers
Master Cylinder
Spring
Main Piston
ASSEMBLY
Before assembly, apply brake fluid to all
removed parts.
Install the spring together with the 1st rubber
cup.
*
• During assembly, the master cylinder,
main piston and spring must be installed as
a unit without exchange.
• When assembling the piston, soak the
cups in brake fluid for a while.
Install the main piston and snap ring.
MX'er SYSTEM
Snap Ring
13-20