KYMCO MX’er 125 Service Manual page 172

13
. REAR WHEEL/SWING ARM/
HYDRAULIC BRAKE
BRAKE PAD/DISK
BRAKE PAD REPLACEMENT
Remove the two bolts attaching the brake
caliper holder.
*
The brake pads can be replaced without
removing the brake fluid tube.
Remove the brake caliper.
Push the brake caliper holder and then remove
brake pad.
Remove the other brake pad and pad springs.
ASSEMBLY
Assemble the brake pads in the reverse order
of removal.
Brake Lever
Bleed Valve
Brake Caliper Holder
Brake Bad
BRAKE DISK
Measure the brake disk thickness.
Service Limit: 3.0mm
Measure the brake disk run out.
Service Limit: 0.3mm
MX'er SYSTEM
Bolts
Brake Bad
Pad Spring
13-18