KYMCO MX’er 125 Service Manual page 61

4
. LUBRICATION SYSTEM
the pump shaft.
Install and tighten the pump driven gear nut.
Torque: 0.8 1.2kgf-m
Install the oil separator cover and tighten the
bolts.
Install the starter idle gear and starter clutch.
Install the starter clutch nut and tighten it to
specified torque..
Torque: 9.5 kgf-m
Install the gasket and dowel pins.
Install the A.C. generator flywheel.
Install the right crankcase cover.
Torque: 0.8 1.2kgf-m
*
Diagonally tighten the bolts in 2 3 times.
4-7
Nut
Bolts
Oil Separator Cover
Starter Clutch
Starter Idle Gear
Flywheel
MX'er SYSTEM
Pump Driven Gear
Dowel Pin
Gasket