KYMCO MX’er 125 Service Manual page 145

12
. FRONT WHEEL/FRONT BRAKE/FRONT
SUSPENSION/STEERING SYSTEM
Inspect the front arm.
Replace if cracks, bends or damage.
*
Do not attempt to straighten a bent arm,
this may dangerously weaken the arm.
Inspect bushes.
Replace if wear or damage.
INSTALLATION
Reverse the "REMOVAL" procedures.
*
Apply the grease onto the bushes, collars
and covers.
Install the front arm nut onto the frame and
tighten the nuts.
Torque: 4.0 5.0kgf-m
Apply the grease onto the bush, collars and
covers, then install the steering knuckle onto the
front arm and tighten the nut.
Torque: 4.0 5.0kgf-m
12-11
Bushes
Install the cotter pin and band ends of cotter
pin.
*
Always use a new cotter pin.
MX'er SYSTEM