KYMCO MX’er 125 Service Manual page 152

12
. FRONT WHEEL/FRONT BRAKE/FRONT
SUSPENSION/STEERING SYSTEM
Install the tie rods and tighten the nut.
Torque: 4.0 5.0kgf-m
Install the cotter pin and band ends of cotter
pin.
*
Always use a new cotter pin.
*
Be sure that the rod-end on the
indentation surface side is connected to
the steering column.
Install handlebar and handlebar holder, then
tighten the four bolts.
Torque: 1.8 2.5kgf-m
Cotter Pin
Cotter Pin
Nut
Bolts
Nut
*
• Be sure the upper handlebar holder mark
face to front.
• Fist tighten the bolts on the front side of
the handlebar holder, and then tighten the
bolts on the rear side.
MX'er SYSTEM
Nut
Tie-rod
Indentation Surface
Headlight Unit
Bolts
Cotter Pin
Handlebar
12-18