KYMCO MX’er 125 Service Manual page 12

1
. GENERAL INFORMATION
n After routing, check that the wire harnesses
are not twisted or kinked.
n Wire harnesses routed along with handlebar
should not be pulled tight, have excessive
slack or interfere with adjacent or
surrounding parts in all steering positions.
n When a testing device is used, make sure to
understand the operating methods thoroughly
and operate according to the operating
instructions.
n Be careful not to drop any parts.
n When rust is found on a terminal, remove the
rust with sand paper or equivalent before
connecting.
MX'er SYSTEM
Do you understand
the instrument? Is
the instrument set
correctly?
Remove Rust !
1-10