KYMCO MX’er 125 Service Manual page 138

12
. FRONT WHEEL/FRONT BRAKE/FRONT
SUSPENSION/STEERING SYSTEM
Place the machine on a level place.
Remove four nuts attaching the wheel panel
and front wheel.
Elevate the front wheels by placing a suitable
stand under the frame.
*
Support the machine securely so there is no
danger of it falling over.
Remove the cotter pin.
Remove nut attaching the wheel hub and
washer.
Remove the collar and wheel hub.
FRONT BRAKE DISASSEMBLY
Loosen the lock nut and tighten the adjuster nut
at brake lever. (Refer to the "FRONT BRAKE
ADJUSTMENT" section in the CHAPTER
3.).
Disconnect the front brake cable from brake
cam lever and remove the brake panel.
Remove the brake shoes.
REMOVE
Remove brake shoes and springs.
Remove the bolt attaching camshaft lever
and remove camshaft lever.
Remove the wear indicator, camshaft and O-
rings
Nut
Pin
Wheel Hub
Front Wheel Wheel Panel Nuts
Brake Cable
Brake Shoes
Camshaft lever Brake Panel
Wear Indicator
O-rings
Measure the wheel run out.
Replace wheel or check bearing play if out
MX'er SYSTEM
Washer
Collar
Hub Nut
Brake Panel
Springs
Brake Shoes
12-4