KYMCO MX’er 125 Service Manual page 206

17
. LIGHTS/ SWITCHES
MX'er SYSTEM
INSTALLATION
Install the headlight in the reverse order of
removal.
*
After installation, adjust the headlight beam.
INSTRUMENTS Bulb Socket
Light Shell
REMOVAL
Remove the two headlight attaching bolts.
Remove the headlight and disconnect the
headlight wire coupler.
Remove the two headlight case attaching
screws and disconnect the headlight.
Remove the light shell, rubber boot and bulb
socket.
Check the bulb for damage and replace with a
new one if necessary.
Rubber Boot
INSTALLATION
The installation sequence is the reverse of
removal.
Taillight Shell
STOP LIGHT/TAILLIGHT
Remove the two taillight shell screws and the
shell.
Taillight Shell Screws
Headlight Bulb
Remove the bulb and check the bulb for
17-4