Table of Contents
Advertisement
Solution Ultima 880
Arming The System (On)
AWAY Mode
Press and hold the # key until two beeps are
1.
heard.
Or
Enter your code followed by the # key.
2.
[eg. 2580 + #].
STAY Mode 1
Press and hold the * key until two beeps are
1.
heard.
Or
Enter your code followed by the * key.
2.
[eg. 2580 + *].
STAY Mode 2
Press and hold the 0 key until two beeps are
1.
heard.
Arm All Areas In AWAY Mode
Enter your code followed by 0 and then the #
1.
key [eg. 2580 + 0 + #].
This function allows a code to arm all areas that the
code is assigned to in AWAY Mode at the same time
without the need to arm each area individually.
Disarming The System (Off)
AWAY Mode
Enter your code followed by the # key.
1.
[eg. 2580 + #].
STAY Mode 1
Press and hold the * key until two beeps are
1.
heard (Only if no alarm).
Or
Enter your code followed by the # key.
2.
[eg. 2580 + #].
STAY Mode 2
Press and hold the 0 key until two beeps are
1.
heard (Only if no alarm).
Or
Enter your code followed by the # key.
2.
[eg. 2580 + #].
Quick Reference Guide
Bosch Security Systems Pty Limited
Disarm All Areas
Enter your code followed by 0 and then the #
1.
key [eg. 2580 + 0 + #].
This function allows a code to disarm all areas that
the code is assigned to at the same time without the
need to disarm each area individually.
Isolating Zones
Standard Isolating
Press the * key twice.
1.
Enter the zone number that you want to
2.
isolate followed by the * key.
Repeat step 2 if more than one zone is
required to be isolated.
Press the # key to exit when finished.
3.
Code To Isolate
Press the * key once.
1.
Enter your user code, followed by the * key .
2.
Enter the zone number that you want to
3.
isolate followed by the * key.
Repeat step 2 if more than one zone is
required to be isolated.
Press the # key to exit when finished.
4.
Add/Delete RF Devices (Wireless Zones)
Add RF Device
Enter the Installer Code followed by 0 and the
1.
# key [eg. 1234 + 0 + #].
Enter the Device Number (1 – 16) that you
2.
want to add followed by the # key.
Enter the 9-digit RF device ID number
3.
followed by the # key.
Delete RF Device
Enter the Installer Code followed by 0 and the
1.
# key [eg. 1234 + 0 + #].
Enter the Device Number (1 – 16) that you
2.
want to delete followed by the # key.
Press the * key to delete the RF device.
3.
5
Advertisement
Table of Contents
