Control Panel
3.3.7
Network Access Point Name (APN)
Notice!
Important configuration information for cellular communication
Refer to Configuring for Cellular Service, page 280 for an overview and configuration
information.
Default: wyless.apn
Selections: 0-99 ASCII characters
This parameter sets the IP address for the network access point. Enter up to 99 alphanumeric
characters. The field is case sensitive.
RPS Menu Location
Panel Wide Parameters > Cellular Plug-in Module > Network Access Point Name
3.3.8
Network Access Point User Name
Notice!
Important configuration information for cellular communication
Refer to Configuring for Cellular Service, page 280 for an overview and configuration
information.
Default: Blank
Selections: 0-30 ASCII characters
This parameter specifies the user name for the Network Access Point.
Enter up to 30 alphanumeric characters. The field is case sensitive.
RPS Menu Location
Panel Wide Parameters > Cellular Plug-in Module > Network Access Point User Name
3.3.9
Network Access Point Password
Notice!
Important configuration information for cellular communication
Refer to Configuring for Cellular Service, page 280 for an overview and configuration
information.
Default: Blank
Selections: 0-30 ASCII characters
This parameter sets the password required to access the Network Access Point.
Enter up to 30 alpha-numeric characters. The password is case sensitive.
RPS Menu Location
Panel Wide Parameters > Cellular Plug-in Module > Network Access Point Password
3.3.10
SIM PIN
Notice!
Important configuration information for cellular communication
Refer to Configuring for Cellular Service, page 280 for an overview and configuration
information.
Default: Blank
Selections: 4-8 numbers
Bosch Security Systems, Inc.
Program Entry Guide
Panel Wide Parameters | en
2017.03 | 09 | F.01U.303.998
39