Installation Of The Lamp House - Barco FLM series Service Manual

8.2

Installation of the lamp house

W
ARNING
C
AUTION
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly handled.
Necessary tools
7 mm flat screw driver.
How to install the lamp house of the projector ?
1. Ensure the projector is switched off and the power cord at the projector side is unplugged.
2. Remove the lamp cover, if not removed yet. See "Removal of the lamp cover", page 74.
3. Clasp the lamp house by its handles and gently slide the lamp house into its socket. Note that the compartment is provided with
guides (G) to position the lamp house correctly.
Image 8-4
4. Push the lamp house forward until it slides fully into the projector.
5. Secure the correct position of the lamp house by tightening all three spring lock screws as illustrated.
Image 8-5
6. Reinstall the lamp cover of the projector, see "Installation of the lamp cover", page 82.
R59770072 FLM SERIES 19/03/2007
:
This procedure may only be performed by qualified technical service personnel.
:
Never attempt to disassemble the lamp from its housing or to dispose of it. Return it to Barco.
8. Lamp and lamp house
C
G
91