Installation Of The Input & Communication Unit - Barco FLM series Service Manual

9.2 Installation of the input & communication unit
W
ARNING
Necessary tools
7 mm flat screw driver.
How to install the input & communication unit of the projector ?
1. Ensure that the projector is switched off and the power cord at the projector side is unplugged.
2. Hold the input & communication unit by its handles and gently slide the unit into the guides at the bottom of the input & commu-
nication socket inside the projector.
Image 9-4
3. Push the input & communication unit forward until you feel the connectors of the unit fit in their sockets. The back of the front
plate of the unit must touch the chassis of the projector.
4. Secure the input & communication unit by fastening the four captive screws in the corners of the unit.
Image 9-5
R59770072 FLM SERIES 19/03/2007
:
This procedure may only be performed by qualified technical service personnel.
9. Input & communication unit
97