Removal And Installation Of Projector Covers - Barco FLM series Service Manual

6. REMOVAL AND INSTALLATION OF PROJECTOR
COVERS
About this chapter
Most maintenance and servicing procedures demand removing one or more of the projector covers to gain access to the parts to
maintain or to service. To avoid redundancy, all procedures about cover removing or installing are grouped together in this chapter.
The maintenance and servicing procedures also refer to this chapter if required. The procedures in this chapter describe, with
detailed step by step actions and illustrations, how to remove or install the projector covers. Note that some covers may only be
removed by qualified service personnel, see remarks above each procedure.
W
ARNING
one of the covers, unless otherwise stated.
Overview
• Removal of the front cover
• Removal of the side cover
• Removal of the lamp cover
• Removal of the input cover
• Removal of the back cover
• Removal of the top cover
• Installation of the top cover
• Installation of the back cover
• Installation of the front cover
• Installation of the side cover
• Installation of the lamp cover
• Installation of the input cover
R59770072 FLM SERIES 19/03/2007
:
Always switch off the projector and unplug the power cord at the projector side before removing

6. Removal and installation of projector covers

71