Installation Of The Lamp House - Barco DP K-32B Series User And Installation Manual

Lamp & Lamp House
Image 4-28
3. In case the anode pin drops out the anode support place a plain washer (reference 3) between the UV blocker
and anode support (reference 4). Use a 2.5mm Allen wrench to loosen/fasten the screw (reference 1) of the
anode support. Use a 19mm open-end wrench to capture the anode support.
1
2
Image 4-29

4.7 Installation of the Lamp House

WARNING: This procedure may only be performed by qualified technical service personnel.
CAUTION: Due to its high internal pressure, the lamp may explode in either hot or cold states if
improperly handled.
Required tools
10mm nut driver or flat screw driver.
52 R5905754 /13 DPxK-32B
3
4