Removal Of The Light Processor - Barco FLM series Service Manual

10.2 Removal of the light processor

C
AUTION
side cover in an area which is subject to airborne contaminants such as that produced by smoke machines
or similar.
To remove the side cover, see "Removal of the side cover", page 73.
C
AUTION
Necessary tools
• 5 mm flat screw driver.
• 10 mm nut driver.
How to remove the light processor of the projector ?
1. Remove the lens.
2. Release the two captive screws at the bottom of the light processor as illustrated. Use a 10 mm nut driver or a 5 mm flat screw
driver.
Image 10-2
3. Release the two captive screws at the right side of the light processor as illustrated. Use a 5 mm flat screw driver.
Note: The Formatting Interface Board (FIB) is attached to the light processor and has to be removed from the projector together
with the light processor.
R59770072 FLM SERIES 19/03/2007
:
Remove the light processor of the projector only in a clean and dust free area. Never remove the
:
Remove the lens before removing the light processor !
10. Light processor + light pipe assembly
103