Installation Of The Lamp House - Barco DP K-19B Series User And Installation Manual

Lamp & Lamp House
CAUTION: The "LAMP INFO" parameters which are stored on a chip inside the Lamp House MUST
be updated after each installation of an xenon lamp inside the Lamp House. Neglecting this update
will result in poor performance and short life time of the xenon lamp.
A realignment of the xenon lamp in its reflector is required after the installation of the xenon lamp in
the Lamp House.

4.6 Installation of the Lamp House

WARNING: This procedure may only be performed by qualified technical service personnel.
CAUTION: Due to its high internal pressure, the lamp may explode in either hot or cold states if
improperly handled.
Required tools
10mm nut driver or flat screw driver.
How to install the Lamp House in the projector?
1. Check if the six quarter turn screws turning wires (reference 1Image 4–24) are flush with the cover or
interference will occur while inserting the Lamp House into the projector.
1
Image 4–24
2. Grip the Lamp House by both handles and place the front of the Lamp House on the base plate inside the
lamp compartment of the projector, lining up the foot of the Lamp House with the slots on the base.
3. Push the Lamp House fully into the slots.
4. Secure the Lamp House by fastening the two retaining screws (reference 1 Image 4–25) at the base of the
Lamp House.
5. Reinstall the cover of the Lamp House compartment.
52 R5905753 /17 DPxK-19B/23B/P