8. Lamp and lamp house
8.1
Removal of the lamp house
W
ARNING
C
AUTION
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly handled.
Necessary tools
7 mm flat screw driver.
How to remove the lamp house of the projector ?
1. Switch off the projector and unplug the power cord at the projector side.
2. Remove the lamp cover, see "Removal of the lamp cover", page 74.
3. Release the three spring lock screws of the lamp house as illustrated.
Image 8-2
4. Clasp the lamp house by the handles and pull the lamp house out of the projector.
Image 8-3
While starting up the projector, the electronics detect if a lamp is installed. If no lamp is installed, it is not
possible to start up the projector.
90
:
This procedure may only be performed by qualified technical service personnel.
:
Never attempt to disassemble the lamp from its housing or to dispose of it. Return it to Barco.
R59770072 FLM SERIES 19/03/2007