Removal Of An Input Module - Barco FLM series Service Manual

9. Input & communication unit
9.3

Removal of an input module

The procedure below is applicable to all input modules of the input & communication unit of the projector.
Necessary tools
Phillips screw driver PH1.
How to remove an input module out of the input & communication unit of the projector ?
1. Switch off the projector and unplug the power cord at the projector side.
2. Release the two captive screws of the input module using a Phillips screw driver PH1.
Image 9-6
3. Pull the input module out of the input & communication unit, via the two knobs provided.
Image 9-7
C
AUTION
dummy front plate. After removing one of the input modules, immediately replace with an other one or install
a dummy front cover on the unused input slot.
98
:
Ensure that all unused input slots of the input & communication unit are always covered with a
R59770072 FLM SERIES 19/03/2007