Removal Of The Lamp Cover - Barco FLM series Service Manual

6. Removal and installation of projector covers
6.3

Removal of the lamp cover

W
ARNING
Necessary tools
7 mm flat screw driver.
How to remove the lamp cover of the projector ?
1. Release the two captive screws at the top and bottom right side of the lamp cover, using a flat screw driver.
Image 6-5
2. Remove the lamp cover from the projector doing the following:
a) gently pull out the left bottom corner (A) of the lamp cover,
b) then gently pull out the left top corner (B) of the lamp cover,
c) then move the lamp cover away from the projector (C).
Image 6-6
74
:
This procedure may only be performed by qualified technical service personnel.
R59770072 FLM SERIES 19/03/2007