7. DUST FILTERS
About this chapter
This chapter contains detailed information about the replacement of the dust filters. The FLM projector has three high density filters
which can easily be replaced. One at the front side, one at the bottom side (under the heat exchanger) and one at the top side
(above the cold mirror).
A
Image 7-1
A
Front high density filter.
B
Bottom high density filter (located under the heat exchanger).
C
Top high density filter (located above the cold mirror).
C
AUTION
ronment conditions of the projector.
HEPA
High Efficiency Particulate Absorbing
Available kits
Order info
R9854470
R9854480
Overview
•
Replacement of the dust filter on the front side
•
Replacement of the dust filter on the bottom side
•
Replacement of the dust filter on the top side
R59770072 FLM SERIES 19/03/2007
:
All HEPA filters of the FLM projector must be replaced on a regular basis, depending on the envi-
Description
FLM front, bottom and top filters (6 pieces each)
FLM front, bottom and top filters (24 pieces each)
B
7. Dust filters
C
85