Setting: T2 Time Out; Setting: Ta Time Out/Tb1 Time Out - Kyocera TASKalfa 1800 Service Manual

Setting: T2 time out

The T2 time-out time decides the following.
From CFR signal output to image data reception
From image data reception to the next signal reception
In ECM, from RNR signal detection to the next signal reception
1. Change the setting using the right/left arrow keys.
T2 time-out time
2. Press the start key. The value is set.
Setting: Ta time out
In the fax/telephone auto select mode, sets the time to continue ringing an operator through the
connected telephone after receiving a call as a fax machine (see figure 1-3-19). A fax signal is
received within the Ta set time, or the fax mode is selected automatically when the time elapses. In
fax/telephone auto select mode, change the setting when fax reception is unsuccessful or a tele-
phone fails to receive a call.
1. Change the setting using the right/left arrow keys.
Ta time-out time
2. Press the start key. The value is set.
Setting: Tb1 time out
In the fax/telephone auto select mode, sets the time to start sending the ring back tone after
receiving a call as a fax machine (see figure 1-3-19). In fax/telephone auto select mode, change
the setting when fax reception is unsuccessful or a telephone fails to receive a call.
1. Change the setting using the right/left arrow keys.
Tb1 time-out time
2. Press the start key. The value is set.
Description
Description
Tb1
Tb2
Figure 1-3-19 Ta/Tb1/Tb1-3-192 time-out time
Description
1-3-101
2NC/2NF/2NG/2NN/3P7/3P8/3P9-2
Setting range
1 to 255
Setting range
1 to 255
Ta
Setting range
1 to 255
Initial setting
69
Initial setting
30
Initial setting
20