Kyocera TASKalfa 1800 Service Manual page 346

37. Remove the screw.
38. Remove the exit rear cover forward with
releasing two projections by lifting it up.
39. Remove the connector from the high
voltage PWB.
40. Remove three screws and unhook the
hook and then remove the high voltage
PWB.
41. Check or replace the high voltage PWB
and refit all the removed parts.
Projection
Figure 1-5-118
High voltage PWB
High voltage PWB
Figure 1-5-119
1-5-68
2NC/2NF/2NG/2NN/3P7/3P8/3P9
Projection
Screw
Exit rear cover
Connector
Screw
Screw
Screw
Hook