Scanner Auto Adjustment; Methods: [Table]/[Dp] - Kyocera TASKalfa 1800 Service Manual

U411

Scanner Auto Adjustment

Description
Uses a specified original and automatically adjusts the following items in the scanner and the DP
scanning sections.
Scanner section: Original size magnification, leading edge timing, center line, input gamma, input
gamma in monochrome mode and matrix.
DP scanning section: Original size magnification, leading edge timing, center line.
Purpose
To perform automatic adjustment of various items in the scanner and the DP scanning sections.
Method
1. Press the start key.
2. Select the item. The screen for executing is displayed.
Display
Table
DP
All
Method: [Table ]
1. Enter the value for [Adjust Original] using maintenance item U425.
2. Set a specified original (P/N: 7505000005) on the platen.
3. Enter maintenance item U411.
4. Select [Table].
5. Press the start key. Auto adjustment starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem occurs
during auto adjustment, error code is displayed and operation stops. Should this happen,
determine the details of the problem and repeat the procedure from the beginning.
Method: [DP]
1. Enter the value for [Adjust Original] using maintenance item U425.
2. Set a specified original (P/N: 302AC68243) on the DP face up.
3. Enter maintenance item U411.
4. Select [DP].
5. Press the start key. Auto adjustment starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem occurs
during auto adjustment, error code is displayed and operation stops. Should this happen,
determine the details of the problem and repeat the procedure from the beginning.
Description
Automatic adjustment in the scanner sec-
tion.
Automatic adjustment in the DP scanning
section.
Performs automatic adjustment in the DP
scanning section following automatic
adjustment in the scanner section.
1-3-75
2NC/2NF/2NG/2NN/3P7/3P8/3P9-5
Original to be used for
adjustment (P/N)
7505000005
302AC68243
-