Kyocera TASKalfa 1800 Service Manual page 58

Item
Section
No.
Operation U203 Chk DP Ope
panel and
support
U204 Set Card/Counter
equipment
U207 Chk Panel Key
U211 Set EH Connection
U223 Lock panel Ope
U243 Chk DP motors
U244 Chk DP Switch
Mode set- U250 Mnt Cnt Pre-set
ting
U251 Clr Mnt Cnt
U252 Set Dest
U253 Sel D/S count
U260 Set Count Mode
U265 Set Model Dest
U285 Set Svc Sts Page
U326 Set clean Bk Line
U332 Adj Calc Rate
U341 Set Prn Cass
U343 Set Dup PriMode
U345 Set Mnt Time Disp
U346 Slct Sleep mode
Content of maintenance item
2NC/2NF/2NG/2NN/3P7/3P8/3P9-2
Each simulation is operated with DP simple
substance.
The presence or absence of a key card
and a key counter is set up.
An operation key is checked.
The presence or absence of a duplex unit
is changed.
The operation functions of operation panel
are changed. (Advanced model only)
Operation of the motor of DP, a clutch, and
a solenoid is checked.
The state of the paper detection SW of DP
is displayed.
The preset value (number of sheets) of a
maintenance cycle is set up.
A maintenance counter are displayed and
the data are changed.
The destination is set up.
The copy count methods (double count),
such as a total counter, are set up.
The timing (feeding or ejection) which a
total count etc. count is changed.
The consecutive numbers of the OEM are
set up.
A coverage report output (permission or
failure) is channged.
An announcement (a display -- or undis-
played) when black line is detected is set
up.
The coefficient of the fixed form external
application paper to A4 (or 11x8.5) paper is
set up.
The cassette stage only for a printer is set
up.
A default (Duplex copy or Simplex copy) by
a copy is set up.
The number of sheets of a check close dis-
play is set up.
A BAM conformity country is set up.
1-3-4
Summary