Setting The T2 Time-Out Time; Setting The Ta Time-Out Time; Setting The Tb1 Time-Out Time - Kyocera FS-C8520MFP Service Manual

Item No.
U641

Setting the T2 time-out time

The T2 time-out time decides the following.
From CFR signal output to image data reception
From image data reception to the next signal reception
In ECM, from RNR signal detection to the next signal reception
1. Change the setting using the cursor left/right keys.
T2 time-out time
2. Press the start key. The value is set.

Setting the Ta time-out time

In the fax/telephone auto select mode, sets the time to continue ringing an operator through the
connected telephone after receiving a call as a fax machine (see figure 1-3-20). A fax signal is
received within the Ta set time, or the fax mode is selected automatically when the time elapses.
In fax/telephone auto select mode, change the setting when fax reception is unsuccessful or a
telephone fails to receive a call.
1. Change the setting using the cursor left/right keys.
Ta time-out time
2. Press the start key. The value is set.

Setting the Tb1 time-out time

In the fax/telephone auto select mode, sets the time to start sending the ring back tone after
receiving a call as a fax machine (see figure 1-3-20). In fax/telephone auto select mode, change
the setting when fax reception is unsuccessful or a telephone fails to receive a call.
1. Change the setting using the cursor left/right keys.
Tb1 time-out time
2. Press the start key. The value is set.
Description
Description
Tb1
Figure 1-3-20 Ta/Tb1/Tb2 time-out time
Description
1-3-114
Description
Setting
range
1 to 255 69
Setting range
1 to 255
Ta
Tb2
Setting
range
1 to 255 20
Initial Change in value
setting per step
100 ms
Initial setting
30
Initial Change in value
setting per step
100 ms
2MY/2MZ