Kyocera TASKalfa 1800 Service Manual page 59

Item
Section
No.
Image pro- U402 Adjust margin
cessing
U403 Scan Margin Tbl
U404 Scan margin DP
U411 Scanner Auto Adjustment
U425 Set Target
FAX U600 Init All Data
U601 Init Keep Data
U603 User Data 1
U604 User Data 2
U605 Clr Data
U610 System Setting 1
U611 System Setting 2
U615 System Setting 6
U620 FAX System
U625 Set Comm
U630 Comm Ctrl 1
Content of maintenance item
2NC/2NF/2NG/2NN/3P7/3P8/3P9-2
The space of a leading edge, AC side, and
a trailing edge is adjusted.
The margin of reading data is adjusted by
picture reading by a scanner.
The margin of reading data is adjusted by
picture reading by DP
A scanner and DP are adjusted automati-
cally.
The target value of an adjustment original
is set up.
According to the country code and the
OEM code which were inputted, all the
softswitches, backup data, and an image
memory are initialized.
Softswitches other than machine data are
initialized according to the country code
and the OEM code which were inputted.
A circuit class is set up.
The number of times of a bell at the time of
a FAX/TEL automatic change is set up.
All the data of a communication history and
a protocol list is cleared.
The number of waste lines at the time of
degree, the number of waste lines at the
time of automatic reduction, and the num-
ber of waste lines at the time of automatic
reduction (A4, LETTER) are set up.
The number of adjustment lines at the time
of automatic reduction and the number of
adjustment lines at the time of automatic
reduction (A4, LETTER) are set up.
Recording width capability and a disposal
method when an 11-inch width recording
form is set by an inch system are set up.
Remote change mode (a continued type /
one shot type) is set up.
The interval of a redial and the number of
times are set up.
Transmitting start speed and receiving abil-
ity speed are set up.
The measure against an echo at the time
of transmission/reception is set up.
1-3-5
Summary