IBM X3950 X5 Problem Determination And Service Manual page 129

6. Remove the battery:
a. Use one finger to push the battery horizontally out of its housing.
b. Lift the battery from the socket.
7. Dispose of the battery as required by local ordinances or regulations.
Replacing the battery
This topic provides instructions for how to install the replacement battery.
About this task
The following notes describe information that you must consider when you replace
the battery in the server:
v You must replace the battery with a lithium battery of the same type from the
same manufacturer.
v After you replace the battery, you must reconfigure the server and reset the
system date and time.
v To avoid possible danger, read and follow the following safety statement.
Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 15F8409 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode if
not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the replacement battery, complete the following steps:
Procedure
1. Follow any special handling and installation instructions that come with the
replacement battery.
2. Locate the battery connector (see "I/O-board connectors" on page 26).
Chapter 5. Removing and replacing components
113