Table of Contents
Advertisement
62
1-1. For safe use
NOTE:
1
*
: Adjust the front seatback to the most upright position. Move the front seat
cushion to the fully rearward.
Adjust the seat cushion to the highest position. When the child restraint sys-
tem touched the ceiling, lower the seat position.
Follow these procedures
• For installing a baby seat with support base
If the baby seat interferes with the seatback when latching the baby seat
into the support base, adjust the seatback rearward until there is no interfer-
ence.
• For installing a forward-facing child seat
If there is gap between the child seat and the seatback, tilt the seatback rear-
ward until good contact is achieved.
If the seatbelt shoulder anchor is ahead of the child seat belt guide, move
the seat cushion forward.
• For installing a junior seat
If the child in your child restraint system is in a very upright position,
adjust the seatback to the most comfortable position.
If the seat belt shoulder anchor is ahead of the child seat belt guide, move
the seat cushion forward.
2
*
: Remove the head restraint if it interferes with your child restraint system.
3
*
: When using the left side seat for the child restraint system, do not sit in the
center seat.
The child restraint system mentioned in the table may not be available
outside of the EU area.
Other child restraint systems which are different from the systems men-
tioned in the table can be used, but the suitability of the systems must be
carefully checked with the child restraint system manufacturer and
retailer.
IS250_EE(OM53B11E)
Advertisement
Table of Contents
