Lexus 2013 IS250 Owner's Manual page 255

Setting up Lexus parking assist-sensor
You can change the warning beep volume and Lexus Display Audio
screen operating conditions.
1
Press the "MENU" button on the Lexus Display Audio controller. (P.
294)
2
Select "Setup" on the "Menu" screen.
3
Select "Vehicle" on the "Setup" screen.
4
Select "LEXUS park assist" on the "Vehicle settings" screen.
5
Select the desired button.
1
The alert volume can be
adjusted.
2
On or off can be selected for
Lexus parking assist-sensor
display.
3
Front or rear center sensors
display and tone indication can
be set.

The Lexus parking assist-sensor can be operated when

Front center sensors:
• The engine switch is in IGNITION ON mode.
• The shift lever is in a position other than P or R.
• The vehicle speed is less than about 10 km/h (6 mph).

Front corner sensors:
• The engine switch is in IGNITION ON mode.
• The shift lever is in a position other than P.
• The vehicle speed is less than about 10 km/h (6 mph).
(At any speed when the shift lever is in R)

Rear corner and rear center sensors:
• The engine switch is in IGNITION ON mode.
• The shift lever is in R.

Lexus parking assist-sensor display
When an obstacle is detected while the rear view monitor system is in use, the
warning indicator will appear in the top right of the screen even if the display set-
ting has been set to off.
IS250_EE(OM53B11E)
4-5. Using the driving support systems
253
4