Lexus 2013 IS250 Owner's Manual page 529

514
8-2. Steps to take in an emergency
12
Start the engine.
13
To inject the sealant and inflate
the tire, turn the compressor
switch on.
14
Inflate the tire until the specified
air pressure is reached.
1
The sealant will be injected and
the pressure will surge and then
gradually decrease.
2
The air pressure gauge will dis-
play the actual tire inflation pres-
sure about 1 minute (5 minutes at
low temperature) after the switch
is turned on.
3
Inflate the tire until the specified
air pressure.
• Turn the compressor switch off
and then check the tire inflation
pressure. Being careful not to
over inflate, check and repeat the
inflation procedure until the
specified tire inflation pressure is
reached.
• If the tire inflation pressure is still lower than the specified point after
inflation for 35 minutes with the switch on, the tire is too damaged to
be repaired. Turn the compressor switch off and contact any authorized
Lexus dealer or repairer, or another duly qualified and equipped pro-
fessional.
• If the tire inflation pressure exceeds the specified air pressure, let out
some air to adjust the tire inflation pressure. (P. 518, 544)
IS250_EE(OM53B11E)