Lexus 2013 IS250 Owner's Manual page 125


Switching the door unlock function (vehicles with entry function)
It is possible to set which doors the entry function unlocks using the wireless
remote control.
1 Turn the engine switch off.
2 Cancel the intrusion sensor and tilt sensor of the alarm system to prevent unin-
tended triggering of the alarm while changing the settings. (if equipped) (P.
86)
3 When the indicator light on the key surface is not on, press and hold
or
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least 5
seconds, and repeat step
Multi-information
display
(Left-hand drive
vehicles)
(Right-hand drive
vehicles)
For vehicles with an alarm: To prevent unintended triggering of the alarm,
unlock the doors using the wireless remote control and open and close a door
once after the settings have been changed. (If a door is not opened within 30 sec-
onds after
automatically be set.)
In a case that the alarm is triggered, immediately stop the alarm. (P. 84)
IS250_EE(OM53B11E)
3-2. Opening, closing and locking the doors and trunk
for approximately 5 seconds while pressing and holding
3 .)
Unlocking function
Holding the driver's door
handle unlocks
driver's door.
Holding a passenger's door
handle unlocks all the doors.
Holding a door
unlocks all the doors.
is pressed, the doors will be locked again and the alarm will
Beep
only the
Exterior: Beeps
times
Interior: Pings once
handle Exterior: Beeps twice
Interior: Pings once
123
,
.
3
3