Table of Contents
Advertisement
15
With the compressor switch off, disconnect the hose from the valve on
the tire and then pull out the power plug from the power outlet socket.
Some sealant may leak when the hose is removed.
16
Install the valve cap onto the valve of the emergency repaired tire.
17
Attach the air release cap to the
end of the hose.
If the air release cap is not attached,
the sealant may leak and the vehicle
may get dirty.
18
Temporarily store the bottle in the luggage compartment while it is
connected to the compressor.
19
To spread the liquid sealant evenly within the tire, immediately drive
safely for about 5 km (3 miles) below 80 km/h (50 mph).
20
After driving for about 5 km (3
miles), stop your vehicle in a safe
place on a hard, flat surface and
remove the air release cap from
the hose before reconnecting the
repair kit.
IS250_EE(OM53B11E)
8-2. Steps to take in an emergency
515
8
Advertisement
Table of Contents
