Table of Contents
Advertisement
518
8-2. Steps to take in an emergency
If the tire is inflated to more than the recommended level
1
Disconnect the hose from the valve.
2
Install the air release cap to the end of the
hose and push the protrusion on the air
release cap into the valve to let some air
out.
3
Disconnect the hose from the valve, remove the air release cap from the hose
and then reconnect the hose.
4
Turn the compressor switch on and wait for several seconds, then turn it off.
Check that the air pressure indicator shows the recommended level. (P. 544)
If the air pressure is lower than the recommended level, turn the compressor
switch on again and repeat the inflation procedure until the recommended pres-
sure is reached.
CAUTION
Caution while driving
Observe the following precautions.
Failure to do so may cause an accident.
The emergency tire puncture repair kit is made exclusively for your vehicle.
Do not use it on other vehicles.
Do not use the emergency tire puncture repair kit for tires that are a different
size than the specified ones or for any other purpose. Doing so may cause the
tires to not be repaired properly.
Precautions for use of the sealant
Ingesting the sealant is hazardous to your health. If you ingest sealant, con-
sume as much water as possible, then immediately consult a doctor.
If sealant gets in eyes or adheres to skin, immediately wash it off with water.
If discomfort persists, consult a doctor.
IS250_EE(OM53B11E)
Advertisement
Table of Contents
