Kyocera TASKalfa 2551ci Service Manual page 451

Hide thumbs Also See for TASKalfa 2551ci:

Table of Contents

3. Reset machine settings.( Resets system menu settings modified at setup to their defaults.)

Main items for settings

[Date/Timer] - Date/Time settings

[Date/Timer] - Timer settings (Sleep timer)

[Edit Destination] - One-touch presetting

[User/Job accounting] - Defaults for user authentication and job accounting only.

*: If the IP address has been changed to a printer name in printer settings, set the IP address again.

Procedures to be followed after the EEPROM on the main PWB has been replaced

1. Run U004 – model number entry.

The C0130 (mismatching model number) is displayed when the device is powered up after its EEPROM

has been replaced. Restore the counter values and serial number that are stored in the engine

2. Referring to the maintenance report that was printed using U000 at setup, set the following maintenance

1) U252 - Setting the destination

2) U265 - Setting OEM purchaser code

3. Run the following maintenance mode for image adjustment:

1) U410 – Adjusting the halftone automatically

When connecting the hard disk cables (YC1, YC2) to the PWB, match "BLACK" and "BLUE" marked on the

PWB with the connector colors.

Resettings are not required as the data are stored in harddisk.

Figure 1-5-72

Show Quick Links

Table of Contents