Mechanical Problems - Kyocera TASKalfa 2551ci Service Manual

Hide thumbs Also See for TASKalfa 2551ci:
Table of Contents

Advertisement

1-4-5 Mechanical problems

If the part causing the problem was not supplied, use the unit including the part for replacement.
Problem
(1)
No primary paper
feed.
(2)
No secondary paper
feed.
(3)
Skewed paper feed.
(4)
Multiple sheets of
paper are fed.
(5)
Paper jams.
(6)
Toner drops on the
paper conveying path.
(7)
Abnormal noise is
heard.
Causes/check procedures
Check if the surfaces of the following roll-
ers are dirty with paper dusts.
Pickup roller
Paper feed roller
MP paper feed roller
Check if any of the following rollers is
deformed.
Pickup roller
Paper feed roller
MP paper feed roller
Defective paper feed clutch installation.
Check if the surfaces of the following roll-
ers are dirty with paper powder.
Right registration roller
Left registration roller
Defective registration clutch installation.
Paper width guide in the cassette are
installed incorrectly.
Check if the paper is excessively curled.
Paper is loaded incorrectly.
Check if the retard roller is worn.
Check if the paper is excessively curled.
Check if the contact between the right
and left registration rollers is correct.
Check if the heat roller or press roller is
extremely dirty or deformed.
Check if the drum unit or developer unit
is extremely dirty.
Check if the rollers, pulleys and gears
operate smoothly.
Check if the following clutches are
installed correctly.
Paper feed clutch
Mid clutch
Registration clutch
Duplex clutch
Clean with isopropyl alcohol.
Check visually and replace any
deformed (see page 1-5-8, 1-5-9).
Check visually and remedy if necessary.
Clean with isopropyl alcohol.
Check visually and remedy if necessary.
Check the paper width guide visually
and remedy or replace if necessary.
Change the paper.
Load the paper correctly.
Replace the retard roller if it is worn
(see page 1-5-8).
Change the paper.
Check visually and remedy if necessary.
Check visually and replace the fuser
unit (see page 1-5-17).
Clean the drum unit or developer unit.
Grease the bushes and gears.
Check visually and remedy if necessary.
1-4-88
Corrective measures
2NP

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents