Config Dhcp_Relay Option_82 - D-Link DGS-3200 SERIES Cli Manual

Format
config dhcp_relay delete ipif <ipif_name 12> <ipaddr>
Description
The config dhcp_relay delete command is used to delete one or all of the IP destination addresses in the
swith's relay table.
Parameters
Parameters
ipif_name
ipaddr
Restrictions
You must have administrator privileges.
Examples
To delete a DHCP/BOOTP server to the relay table.
D G S - 3 2 0 0 - 1 0 : 4 # c o n f i g d h c p _ r e l a y d e l e t e i p i f S y s t e m 1 0 . 4 3 . 2 1 . 1 2
C o m m a n d : c o n f i g d h c p _ r e l a y d e l e t e i p i f S y s t e m 1 0 . 4 3 . 2 1 . 1 2
S u c c e s s .
D G S - 3 2 0 0 - 1 0 : 4 #

44-4 config dhcp_relay option_82

Purpose
Used to configure the DHCP relay agent information option 82 of the switch.
Format
config dhcp_relay option_82 { state [enable|disable] | check [enable|disable] | policy
[replace|drop|keep] }
Description
The config dhcp_relay option_82 command configures the DHCP relay agent information option 82
setting of the switch.
The formats for the circuit ID suboption and the remote ID suboption are as following. For the circuit ID
suboption of a standalone switch, the module field is always zero.
Circuit ID suboption format :
1. 2.
1
1 byte 1 byte
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
The name of the IP interface which contains the IP address below.
The DHCP/BOOTP server IP address.
3. 4.
6 0 4
1 byte 1 byte
5.
VLAN
2 bytes
393
6. 7.
Module Port
1 byte 1 byte