Dedicated Transmission Parameters; Programming Procedure - Ricoh B121 Service Manual

Hide thumbs Also See for B121:

Table of Contents

3.4 DEDICATED TRANSMISSION PARAMETERS

Each Quick Dial Key has eight bytes of programmable parameters allocated to it. If

transmissions to a particular machine often experience problems, store that

terminal's fax number as a Quick Dial and adjust the parameters allocated to that

The programming procedure will be explained first. Then, the eight bytes will be

1. Set bit 0 of System Bit Switch 00 to 1.

2. Select the menus as follows: User Tools → System Settings → Key Operator

Tools → Address Book Management → Program/Change

3. Select the destination key you want to program, then press "OK" two times.

4. Press "Dest." key, then select "Fax Settings."

5. When the programmed dial number is displayed, press "Start." Make sure that

the LED of the Start button is lit as green.

6. The Switch numbers are displayed (00 ∼ 09). Select the switch number, then

7. The settings for specified switch are displayed. Press the bit number that you

wish to change, then press "OK."

8. To select the parameter switches, use the arrow key.

9. To exit, press the "Cancel" key.

10. After finishing, reset bit 0 of System Bit Switch 00 to 0.

DEDICATED TRANSMISSION PARAMETERS

Table of Contents

B259 B260 B261 B122 B123