SERVICE PROGRAM MODE
Starting SSP Mode
For the basic machine (the machine without the optional controller box), perform as
listed in steps 1 through 4. For the MFP machine (the machine with the optional
controller box), perform as listed in steps 1 through 5.
1. Type the keys as follows: → → →
2. Press the key and hold it down until the SP-mode menu is displayed (about
3 seconds).
3. Press the key and hold it down.
4. While holding down the key, press the key (on the numeric keypad).
5. While holding down the key, press the "OK" key.
Selecting Programs
• When a blinking underscore (or several blinking underscores) is displayed, you
can type a number from the numeric keypad [D].
• When the sign " /OK" [A] is displayed upper right corner, you can scroll
through the menu by pressing the left-arrow key [B] or the right-arrow key [C]. To
select a program, press the OK key [F].
Specifying Values
1. After locating a program, press the OK key. A blinking underscore (or several
blinking underscores) indicates which value you can change. The value in
parentheses is the default value of the menu.
2. Type a necessary value from the numeric keypad. To switch between positive
(plus) and negative (minus) values, press the key.
3. To validate the value, press the OK key. To cancel the value, press the cancel
key [E].
Activating Copy Mode
You can activate the copy mode while the SP mode is running. When you do so,
the copier outputs images or patterns that help you adjust the SP-mode program.
1. Press the key. The copy mode is activated.
2. Specify copy settings and press the key.
3. To return to the SP mode, press the key.
NOTE: You cannot end the SP mode while the copy mode is activated.
Quitting Programs/Ending (S)SP Mode
Press the key or the cancel key to quit the program. You can end the SP
mode by pressing one of these keys several times.
B121 Series/B259 Series
5-2
SM